FUTABA 10J - Adjusting the Length of the Control Sticks; Stick Lever Tension Adjustment

Beforeuse
23
ADJUSTINGTHELENGTHOFTHECONTROLSTICKS
STICKLEVERTENSIONADJUSTMENT
<RXPD\DGMXVWWKHWHQVLRQRI\RXUVWLFNVWRSURYLGHWKHIHHOWKDW\RXSUHIHUIRUÀ\LQJ7RDGMXVW
\RXUVSULQJV \RX¶OO KDYH WR UHPRYHWKH UHDUFDVH RI WKHWUDQVPLWWHU)LUVW UHPRYH WKHEDWWHU\
FRYHURQWKHUHDURIWKHWUDQVPLWWHU1H[WXQSOXJWKHEDWWHU\ZLUHDQGUHPRYHWKHEDWWHU\IURP
WKHWUDQVPLWWHU1H[WXVLQJDVFUHZGULYHUUHPRYHWKHIRXUVFUHZVWKDWKROGWKHWUDQVPLWWHU¶VUHDU
FRYHULQSRVLWLRQDQGSXWWKHPLQDVDIHSODFH*HQWO\HDVHRIIWKHWUDQVPLWWHU¶VUHDUFRYHU1RZ
\RX¶OOVHHWKHYLHZVKRZQLQWKH¿JXUHDERYH
8VLQJDVPDOO3KLOOLSVVFUHZGULYHUURWDWHWKHDGMXVWLQJVFUHZIRUHDFKVWLFNIRUWKHGHVLUHGVSULQJ
tension. The tension increases when the adjusting screw is turned clockwise. When you are
VDWLV¿HGZLWKWKHVSULQJWHQVLRQVUHDWWDFKWKHWUDQVPLWWHUVUHDUFRYHU:KHQWKHFRYHULVSURSHUO\
LQSODFHUHLQVWDOODQGWLJKWHQWKHIRXUVFUHZV5HLQVWDOOWKHEDWWHU\DQGFRYHU
You may change the length of the control sticks to make
your transmitter more comfortable to hold and operate. To
OHQJWKHQRUVKRUWHQ \RXUWUDQVPLWWHU¶VVWLFNVILUVWXQORFN
the stick tip by holding locking piece B and turning stick
WLS$FRXQWHUFORFNZLVH1H[WPRYHWKHORFNLQJSLHFH%
XSRUGRZQWROHQJWKHQRUVKRUWHQ:KHQWKHOHQJWKIHHOV
FRPIRUWDEOHORFNWKHSRVLWLRQE\WXUQLQJORFNLQJSLHFH %
counterclockwise.
Stick tip A Locking piece B
Mode 2 transmitter with rear case removed.
Aileron
Elevator
Rudder
StickStick
Four screws are
removed and rear
case is removed.
+ screw is clockwise.
Stick tension maximum Stick tension minimum
+ screw is counter-clockwise.
Do not loosen
the screw past
the top of the
frame, as this
will cause the
screw to rub on
the back case.
※
A screw touches a case.