FUTABA 10J - Example of Use

93
Commonfunction
Function
6LQFHWKHFKDQQHODQGRSHUDWLRQPRGHXVHGLQWUDLQLQJFDQEHVHOHFWHGWKHWUDLQLQJGLI¿FXOW\FDQEHVHW
to match the student’s level.
The trainer function can be used by connecting the instructor’s transmitter to the student’s transmitter
XVLQJDVSHFLDOWUDLQHUFRUGVROGVHSDUDWHO\6WXGHQWRSHUDWLRQLVSRVVLEOHE\LQVWUXFWRUVZLWFKRSHUDWLRQ,I
the student enters a dangerous situation, control can be immediately switched to the instructor.
● Fouroperationmodescanbeselectedateachchannel.
● ThetrainerswitchissettoswitchH.
Whenthetrainerfunctionisused,thesnaprollfunctionisautomatically
deactivated.
Usethetrainerfunctionunderthefollowingconditions:

● WhentheinstructorusesaT10Jtransmitter,setthestudentʼ stransmittermodulationtoPPM(for
conventionalfrequencytransmitter).(WhenthestudentusesaT10Jtransmitter,themodulation
modedoesnothavetobechanged.APPMsignalisalwaysoutputfromthetrainerjack.)
● Beforeflightalwaysconfirmthatalltheinstructorandstudentchannelsoperatenormallyasset.
● Alwaysinsertthetrainercordasfarasitwillgoandtakemeasuressothatthecordwillnotwork
looseduringuse.
● Alwaysremovethehighfrequencymoduleofthestudentʼ stransmitter.(Formoduletype)
● Neverturnonthestudentʼ stransmitterpowerswitch.
Trainerfunctionoperationmodes
● FNCmode:Thechannelsettothismodecanbecontrolledbythestudentusingthemixingsetat
theinstructorʼ stransmitter.*Studentsettingsarereturnedtotheirinitialvalueinadvance.Next,
reversefunctionmakesallchannelsnormal.
● MIXmode:Thechannelsettothismodeiscontrolledbymixingtheinstructorandstudentsignals.
Correctionrudderisappliedbytheinstructor.Whenthismodeisselected,thestudentʼ srateis
reducedtopreventservooverthrow.Thestudentʼ sratecanalsobeset.*Studentsettingsare
returnedtotheirinitialvalueinadvance.Next,reversefunctionmakesallchannelsnormal.
● NORmode:Thechannelsettothismodeiscontrolledbysignalsfromthestudentʼ stransmitter.(The
instructorandstudentsettingsmustbethesame.)
●OFFmode:Thechannelsettothismodecannotbecontrolledbythestudent.Itcanonlybecontrolled
bytheinstructor.
However,channelsnotprovidedatthestudentʼ stransmitterarecontrolledbytheinstructorregardlessoftheabove
settings.
Whenothermodelsareselected,thetrainerfunctionisdeactivated,butthechannelsettingsremain.
Exampleofuse
● WhentheFUNCmodeissetatthestickchannel,helicopterstickoperationtrainingispossibleeven
witha4EXtransmitter(4channelsforaircraft).
● Controlbytheinstructorispossiblebysettingonlythetrainingchannelmatchedtothestudentʼ s
leveltotheNORMmodeandsettingtheotherchannelstotheOFFmode.
TRAINER
Trainer
(Common)
Teacher
Trainercode
Student
Instructor Student TrainerCords
10J
10C,9C,7C,6EX,4EX
T12FG(FUTM4405)
18MZ,14MZ,14SG,
FX-22,12Z,12FG,
8FG,10J,8J,6J
T12FG(FUTM4405)and9C
(FUTM4415)TrainerCords
18MZ,14MZ,
14SG,FX-22,12Z,
12FG,8FG,10C,
9C,7C,8J,6J,4EX
10J
◆ TrainerCords
CAUTION