FUTABA 10J - Model Select; Model Copy; Date Reset

41
Commonfunction
①SelecttheSELECTitemandthen
selectthemodelnumberby
pressingthe+keyor‒key.
＋ −
or
Selectionrange：1 〜 30
②PresstheJogkeyfor1
second.
 （1second）
● Confirmationmessage
"sure?"blinks.
③ Selectthemodelbypressingthe
Jogkey.
● Aconfirmation"beep
beep"soundstoshowthat
selectioniscomplete.
Forsafety,adoublesettingsystemisused.Whenachangeiscancelledaftertheconfirmationmessageis
displayed,thechangeisnotmadewhenmovedtoanothersettingitembyJogkey.
① SelecttheCOPYitemandtheselect
themodelnumberofthecopy
destinationbypressingthe+key
or‒key.
＋ −
or
Selectionrange：1 〜 30
②PresstheJogkeyfor1
second.
（1second）
● Confirmationmessage
"sure?"blinks.
③Copythemodelbypressingthe
Jogkey.
● Aconfirmation"beep"
soundsand"COMPLETE"
isdisplayedonthescreen
toshowthatcopyingis
complete.
Forsafety,adoublesettingsystemisused.Whenachangeiscancelledaftertheconfirmationmessageis
displayed,thechangeisnotmadewhenmovedtoanothersettingitembyJogkey.
①SelecttheRESTitemandthenpresstheJog
keyfor1second.
（1second）
● Confirmationmessage"sure?"blinks.
② DateresetbypressingtheJogkey.
● Aconfirmation"beep"soundsand
"COMPLETE"isdisplayedonthescreenis
complete.
Forsafety,adoublesettingsystemisused.Whenachangeiscancelledaftertheconfirmationmessage
isdisplayed,thechangeisnotmadewhenmovedtoanothersettingitembyJogkey.
Modelselect
Modelcopy
Datereset
Only the throttle channel (CH3) initial setting is REV (reverse). Thoroughly
check the Hi and Low directions of the engine or motor used and be careful that
they do not suddenly run at full speed. Even after data reset, CH3 is reversed.
CAUTION