FUTABA 10J - Page 40

40
Commonfunction
Function
Method
①Callthemenuscreenfromthe
homescreenbypressingthe+key
for1second.
＋
② Select
fromthemenuwiththeJog
key.
③Openthesettingscreenby
pressingtheJogkey.
（1second）
Callingthesettingscreen
Modelselect（SELECT）
Themodeldataofupto30modelscanbestoredinthetransmitter.Thisfunctionisusedwhen
callingsavedmodeldata.
Modelcopy（COPY）
Thisisthemodeldatacopyfunction.Itisconvenientwhenyouwanttostoremodeldataasbackup
orbuildanumberofmodelswiththesamedatasettings.
● Thedataofthemodelmemorycurrentlyinusecanbecopiedtoanothermodelmemory.
Datareset（RESET）
Themodeldatacurrentlyinusecanberesetto itsinitialvalue.However,it doesnotResetother
thanthefollowingofaparameter.
[Thefunctionresetinaparameter:ATLtrim,TELEMETRYmode,STKPOSIALRM]
Receiverselection（RX）
TheR3008SBsuppliedwiththetransmitter,employstheT-FHSSAirsystem.Whenyouwanttouse
anS-FHSSreceiver,switchtoS-FHSShere.However,thetelemetryfunctioncannotbeusedwiththe
S-FHSSsystem.
Link（LINK）
Whenlinkingwiththereceiver,thetransmitterissettothelinkmodehere.TheIDnumberofthe
currentlylinkedreceiverisdisplayed.
"MDL-SEL"
MDL-SEL
Modelselect（select ／ copy ／ reset ／ RXtype ／ link）
(Common)
Modelselect
Modelcopy
Datareset
RXsystem
Link
（Modelnumber：1 〜 30）
● Originaldata:Modeltype
Modelname
● Copyplace:ModeltypeModel
name
● System（T-FHSSAirorS-FHSS)
●LinkreceiverID
● Selectthesetting
itemwiththeJog
key.
This function is used when calling and copying
model data stored in the transmitter. The selected
model data can also be reset. System changes
(T-FHSS Air, S-FHSS) matched to the receiver type
and linking with the receiver are also done here.
0'/6(/
6(/(㌣02'(/
&23<㌣02'(/
5(67㌣([HFXWH
5;㌣7)+66$LU
/,1.㌣,' ;;;;;;;;;