FUTABA 10J - Page 130

130
Helicopter
■ Mode
①Selectthe"MODE"itemandthenselectthe
modebypressingthe+keyor‒key.
＋ −
or
Range：NOR,ESC
Default：NOR
● "NOR"：Engineplane
 "ESC"：Electricmotorplane
■ Activatingthefunction
②Selectthe"MIX"itemandthenselecttheoff
bypressingthe+keyor‒key.
＋ −
or
● Whenyoudonotuseafunction,settothe
"INH"side.
■ Switchselection
③Selectthe"SW"itemandthenselect
theswitchbypressingthe+keyor‒
key.
＋ −
or
Range：SwA 〜 SwH
Default：SwA
■ Switchdirection
④Selectthe"POSI"bypressingthe+keyor‒keyat
theONdirectionselectionitem.
＋ −
or
Range：
● 2PSW：NULL,UP,DOWN
● 3PSW：NULL,UP,UP&D,UP&C,CNTR,C&DN,
DOWN
■ CutPositionrate
⑤ Selectthe"RATE"itemandthenselect
thechtpositionbypressingthe+keyor
‒key(motorstop).
＋ −
or
● Itadjuststothepositionwhereanengine
iscut.
Range：-30 〜 0 〜 +30%
Default：0%
● Whenyouwanttoreturnthesetvalue
totheinitialvalue,pressthe+keyand‒
keysimultaneously.
（InthecaseofESC）
■ FunctionreleaseThrottlePosition
⑥Selectthe"THR"itemandthenselecttherelease
positionbyTHRstickisloweredandJogkeyis
pressedfor1second.
● Settoasafelowthrottleposition.
Range：0 〜 100%
Default：15%
ThrottleCut