FUTABA 10J - Page 136

136
Helicopter
Function
Method
①Callthemenuscreenfromthe
homescreenby pressingthe +
keyfor1second.
＋
② Select
fromthemenuwiththe
Jogkey.
③Openthesettingscreenby
pressingtheJogkey.
（1second）
Callingthesettingscreen
The pitch curve function allows setting by a 5
point curve in relation to throttle stick movement
and adjustment of each point over the -100%
〜
+100% range so that the pitch enters the optimum
ÀLJKWVWDWH
ŏ1RUPDO125LGOHXS,'/LGOHXS,'/LGOH
XS,'/DQGKROG+/'SLWFKFXUYHVFDQEH
VHW
ŏ7KHQRUPDO125LGOHXS,'/LGOHXS,'/
LGOHXS'/DQGKROG+2/'VZLWFKHVFDQEH
SUHVHWDWWKHFRQGLWLRQVVHOHFWLRQVFUHHQ
NOTE：Whentheholdswitchison,theholdfunctionhas
priorityeventhoughanidleupswitchisinanyposition.
（Normalcurveadjustmentmethod）
Thenormalpitch curvecreatesabasicpitchcurvecenterednearhovering.Thiscurveisadjusted
togetherwiththethrottlepitchcurvesothatenginespeedisconstantandup/downcontrolis
easiest.
（Idleup1/2/3curveadjustmentmethod）
Thehighsidepitchcurvesetsthemaximumpitchthatdoesnotapplyaloadtotheengine.Thelow
sidepitchcurveiscreatedtomatchthepurposesuchasloop,roll,and3D.Theidleup1/2/3curves
areusedbyaerobatics.
（Throttleholdcurveadjustmentmethod）
Thethrottleholdcurveisusedwhenperformingautorotationdives.Settheintermediatepitchto
matchthestickworkatpitchup.
"PIT-CURVE"
PIT-CURVE
Pitchcurve（Forhelicopters）
(HELICOPTER)
Activatingthefunction
Condition
5pointcurve
rate
● Selectthesettingitem
withtheJogkey.
● WhennotusingthisFunction
selectINH. Thedisplayof On/
Offisshownwhenactiveand
assignedtoaswitch.When
normal,"---"(alwaysON)is
displayed.
● ThePIT-CURVEsettingsare
displayedbyacurve.
（Rate） （Presentcondition）
3,7&859(