FUTABA 10J - Page 52

52
Commonfunction
Function
Method
①Callthemenuscreenfromthe
homescreenbypressingthe+key
for1second.
＋
② Select
fromthemenuwiththeJog
key.
③Openthesettingscreenby
pressingtheJogkey.
（1second）
Callingthesettingscreen
The Sub-Trim function is used to set the servo
neutral position, and may be used to make fine
adjustments to the control surface after linkages
and pushrods are hooked up. When you begin to set
up a model, be sure that the digital trims are set to
their center position.
Settingprecautions
Ifsubtrimistoolarge,theservooperatingrange
maybeexceededatmaximumcontrolsurface
angleandgenerateadeadbandinwhichtheservo
doesnotoperate.Firstconnectthelinkagesothat
theamountofsubtrimusedisheldtoaminimum.
"SUBTRIM"
● Selectthechannelwiththe
Jogkey.
● SUBtrimrateofeachchannel.
SUBtrimrateoftheselectedchannel.
SUBTRIM
Subtrim
(Common)
① AchannelischosenbyJogkey.
Selectionrange：
(page1)1 〜 5ch
(page2)6 〜 10ch
②SelecttheSUBtrimyouwanttosetfrom
channelitemandsettheratebypressing
the+keyor‒key.
＋ −
or
Range：
-120 〜 +120%
Default：0%
● Whenyouwantto
returnthesetvalue
totheinitialvalue,
pressthe+keyand‒
keysimultaneously.
Subtrim
68%75,0 

$,/
(/(
7+5
58'
*(5
&+$,/






ڀ
＜ ChannelDisplay ＞
ACROBATIC HELICOPTER GLIDER(AF4) MULTICOPTER
1:AIL（Aileron） 6:FLP（Flap）1:AIL（Aileron） 6:PIT（PITCH）1:AIL（Aileron） 6:FL2（Flap2） 1:AIL（Aileron） 6:AU6
2:ELE（Elevator）7:AU7 2:ELE（Elevator）7:AU7 2:ELE（Elevator）7:AL2（Aileron2）2:ELE（Elevator）7:AU7
3:THR（Throttle）8:AU8 3:THR（Throttle）8:AU8 3:MOT（Motor） 8:FL3（Flap3） 3:THR（Throttle）8:AU8
4:RUD（Rudder）9:AU9 4:RUD（Rudder）9:AU9 4:RUD（Rudder）9:FL4（Flap4） 4:RUD（Rudder）9:AU9
5:GER（Gear） 10:AU0 5:GYR（GYRO） 10:AU0 5:FLP（Flap） 10:AU0 5:MOD 10:AU0