41
Basic Operation
For the sake of safety, this function does not operate the receiver if the model data of the model program settings that
does not match the aircraft is used by mistake.
data. Linking with a receiver stores the model ID of the model data
in that receiver. The receiver operates only when it receives radio
waves transmitted using model data that matches the stored model
ID. As a result, the receiver does not operate even if model data of an
unintended setting is used by mistake, so it is possible to prevent a
malfunction due to a model selection mistake.
Link is required when a new model is made from a model selection.
When using R3004SB
When using the R3004SB, set “Receiver” in the system type screen T-FHSS mode setting to [R3004SB].
When using other T-FHSS compatible receivers, set "Receiver" to [Normal].
R3004SB receiver does not
support model ID function.
Change to "R3004SB"
have been using, link again.
T-FHSS. Please note that model ID function can not be used on other
systems.
models.
To Next Page
Loading...
