＜
Linkage Menu
＞
HELICOPTER
AIRPLANEGLIDER
Servo Reverse changes the direction of an individual
servo’s response to a control stick movement.
For CCPM helicopters, be sure to read the section on
Swash AFR before reversing any servos. With CCPM
helicopters, always complete your servo reversing prior
Glider functions that control multiple servos, it may be
confusing to tell whether the servo needs to be reversed
or a setting in the function needs to be reversed. See
the instructions for each specialized function for further
as an additional precaution to confirm proper model
memory, hook ups, and radio function.
menus. Be sure that all servos are plugged into the proper
receiver channels. Now, determine whether you need to
reverse any channels by moving each stick and observing
the corresponding movement in the model’s controls.
servo operation, the direction of control
surfaces, and switch setup are correct.
Default setting of the motor channel is always
reverse.
To Next Page
Loading...
