54
FLT. TUNE screen 2/3
Cond
(3) Cnt. AuthAIL: Control Authority Aileron
Aileron Control Authority changes the rate at which the gyro will try to
achieve the set "CYC. Rt". A higher value will create a quicker acceler-
ated reaction to a stick input to reach and stabilize to the "CYC. Rt"
value; a lower value will reach the desired "CYC. Rt" slower and acceler-
ate slower to the desired angular rate.
Note: Setting this value too high could lead to a jerky feeling when mak-
ing rapid stick corrections, a value too low will give you the impression
the model is not following the pilot’s stick inputs. Values of between 20-
60 are the suggested range for most helicopters.
Setting ranges: 0 ~ 100%
Initial value: Cnt. AuthAIL = 40%
(4) Cnt. AuthELE: Control Authority Elevator
Elevator Control Authority changes the rate at which the gyro will try
to achieve the set "CYC. Rt". A higher value will create a quicker ac-
celerated reaction to a stick input to reach and stabilize at the "CYC. Rt"
value; a lower value will reach the desired "CYC. Rt" slower and acceler-
ate slower to the desired angular rate.
Note: Setting this value too high could lead to a jerky feeling when mak-
ing rapid stick corrections, a value too low will give you the impression
the model is not following the pilot’s stick inputs. Values of between 20-
60 are the suggested range for most helicopters.
Setting ranges: 0 ~ 100%
Initial value: Cnt. AuthELE = 40%
Cond
Go to 3/3 from any cursor position
From 1/3
To Next Page
Loading...
