97
Servo type: 760
μS
Servo type: 1520
μS
Notes on servo set to 760
μS
To connect the servo set to "DG: 760" or "SWH: 760" to AIL / ELE / PIT / ELE2, set the
servo type to "DG: 760".
To use the servo set to "DG: 760" or "RUD: 760" for RUD, set the servo type to "DG:
760".
Please set the servo type to "DG: 285
Hz" for the AIL / ELE / PIT / ELE2 servo set to "DG:
1520". For RUD servo, set the servo type to "DG: 1520".
When the CH setting is DG
1 or DG
2
If the CH setting is DG
1 or DG
2, the servo type can not be
changed. Before changing to Servo type, you need to set
it to CH
1 to 16 with CH setting and execute "WRITE".
CAUTION
The servo of 760
μS is not connected to ordinary CH, SBUS / SBUS
2
connector such as receiver not compatible.
The servo may be damaged.
Do not set 760
μS servo parameters with transmitter unsupported to
760
μS and PC S-LINK software. Be sure to set parameters with GPB-1.
The servo may be damaged.
CAUTION
Be sure to connect the servo and CGY with the same setting. If you connect a
different setting servo with CGY, the servo may be damaged.
To Next Page
Loading...
