FUTABA FX-36 - Page 100

100
＜ Linkagemenu ＞
Variometer
Setsthevariometer
onwhichthealarm
operates.
↑ Anupwardarrow
indicatesthealarm
willsoundwhenthe
variometerreaches
aboveyoursetvalue.
↓ Adownwardarrow
indicatesthealarm
willsoundwhenthe
variometerreaches
belowyoursetvalue.
Alarmischosenfrom
Buzzer,Voice,and
Inhibit.
AllowsSpeechtobe
turnedONorOFF.
AllowsMelodytobe
turnedONorOFF.
ŏ Tap the [Variometer] button in the Telemetry screen
to call the setup screen shown below.
Max.andmin.values
sincethepower
wasturnedONwill
display.
*It cannot be used in FASST mode and S-FHSS mode.
*Only receiver voltage and EXT voltage can be used in
FASSTest12CH mode.
*The FASSTest18CH /T-FHSS mode can use all the telemetry
functions.
Type1
Type2
Type3
"Vibrator"type
Ifthefollowingtypesareselected,thetransmitter
willvibrateduringthewarning.
First, the set of a reference is required.
1. The model and transmitter to which the
altitude sensor was connected are turned on.
2. Tap to the [Preset] of "Reference" item.
*Atmospheric pressure is changed according to the weather
also at the same air¿eld. You should preset before a Àight.
*AnaltitudesensororGPSsensormustbeinstalledintheaircraft.
Telemetry:Altitude[Variometer]
Displaying data from the
variometer
VARIO is a screen which displays / sets up the
variometer information from an optional altitude
sensor or GPS sensor.
The variometer of the model which is Àying can
be known.
If it becomes higher or lower than the setting, an
alarm and/or vibration will alert you.
To ensure that the pilot is aware as to the model's
status, the FX-36 incorporates a different melody
for ascent and descent. Additionally, depending
upon the rate of climb or descent, the tones vary to
indicate whether or not the airplane is climbing or
descending at a rapid rate.
Alert set : variometer
1. Tap Alarm and choose from Bu]]er, Voice,
and Inhibit.
2. Choose "Inhibit" for Vibrator if no
t
using the
vibrator alarm. If using vibrator, choose one
of the three types.
3. Tap to the Limit [m/s] item .
4. Adjust the rate using the "ʈʈ" "ʈ" "ʆ" "ʆʆ"
buttons.
Initial value: +1m
Adjustment range-50m/s~+50m/s
(ŃLimit
≧
ŅLimit)
*When the screen is tapped for one second, the rate is reset
to the initial value.
5. To terminate the input and return to the
original state, push the H/E button.
● IfthisissettoMode1-4,
ariseanddivearetold
byadifferentmelody.
Mode1:Littlerise/dive
→ Melodychanges
:sensitively
Mode4:Bigrise/dive
→ Melodychanges
:insensible
ŏReturn to
Linkage menu