25
1.2 Operating determinations
This fixture is only allowed to be operated with an alternating current of 230 V/50 Hz.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on
immediately. The arising condensation water might damage your device. Leave the device switched off until it has
reached room temperature.
Never run the device without lamp!
This device was only designed for indoor and professional use.
Do not shake the device. Avoid brute force when installing or operating the device.
Never lift the fixture by holding it at the Moving-Head, as the mechanics may be damaged. Always hold the fixture
at the transport handles.
You can install the device at any desired place in dry rooms. Please make sure that the device is not exposed to
extreme heat, moisture or dust. There should not be any cables lying around. You endanger your own and the
safety of others!
The minimum distance between light-output and the illuminated surface must be more than 1 meter.
Make sure that the area below the installation place is blocked when rigging, derigging or servicing the fixture.
Always fix the fixture with an appropriate safety-rope. Fix the safety-rope at the correct holes only.
Only operate the fixture after having checked that the housing is firmly closed and all screws are tightly fastened.
The lamp must never be ignited if the objective-lens or any housing-cover is open, as discharge lamps may
explose and emit a high ultraviolet radiation, which may cause burns.
Operate the device only after having familiarized with its functions. Do not permit operation by persons not qualified
for operating the device. Most damages are the result of unprofessional operation!
Please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, burns due to ultraviolet radiation, lamp explosion, crash etc.
2. Introduction
Thank you for having chosen a FUTURELIGHT MH-660. You acquired a versatile, powerful and intelligent lighting-
effect.
Unpack your FUTURELIGHT MH-660 and make sure that there are no damages caused by transportation. Should
there be any, please consult your local dealer and do not take the device into operation.
2.1 Features
Moving-head spot
Rotating gobo-wheel with 6 interchangeable and indexable rotating gobos plus open. Rotating gobos: 4 metal
gobos, 1 multicolor dichroic gobo, 1 glass gobo. Rotating gobo-wheel continuous rotation • The rotating gobos can
be turned by 360°, the adjusted position is memorized • 3 additional metal-gobos and 2 glass-gobos are included
• Colour-wheel with 11 dichroic filters plus open. Colour-wheel continuous rotation (rainbow effect) in both directions
• Via the combination between dichro-gobos and color-wheel or multicolor-dichro-gobo even more colour-combinations
possible • Rainbow-effect in both directions • High-speed rotating 3-facet prism • Remotely controllable motorized
focus • Combined shutter/dimmer unit allowing very smooth dimming and strobo effect 1-10 flash per sec. •
Modular construction of fixture • Addressing, special functions setting, effects calibration via control panel with 4-
To Next Page
Loading...