14 ANTI-TIPPERS
540 –UM 1024402 REV08 10/2013 37 Capella / Capella 45
14 Anti-Tippers
WARNING: After ANY adjustments, repair or service and BEFORE use, make sure all attaching hardware is tightened
securely – otherwise injury or damage may occur.
Installing/Adjusting the Anti-Tippers
WARNING: Anti-tippers are specific to the different seat-to floor angles and/or seat-to-floor heights. Refer to the chart in
this section of the manual for correct usage and adjustment. If these requirements CANNOT be achieved, DO NOT us the
wheelchair. Contact a qualified technician. If changing the seat-to-floor height with or without a change to seat-to-floor
angle, the correct anti-tippers MUST be used to maintain a 1 ½“ to 2” ground clearance.
Seat-to-floor angle of 3 degrees to 6 degrees: if so equipped, anti-tippers MUST be attached at all times. In as much as the
anti-tippers are an option on this wheelchair (you may order with or without the anti-tippers), Future Mobility Healthcare
Inc. strongly recommends ordering the anti-tippers as a safeguard for the wheelchair user.
Anti-tippers MUST be fully engaged and snap buttons fully protruding out of adjustment holes.
Ensure both anti-tippers are adjusted to the same mounting hole.
To Next Page
Loading...
