Profession Laser Manufacturer more than 15 Years.
34
Clockwise the emergency stop button to open the machine then open the
computer host
D).Open the laser source
Picture 5-5 Picture 5-6
1.Insert the key into “1”(on the picture 5-5).The key should on the “OFF”
position.→2. Turn on the main switch of the fiber laser source the “2” part on the
picture 5-5)→ 3.Clockwise the “5”(on the picture 5-5) EMERGENCY STOP
switch→4.Press the “LASER POWER” on the machine body .The Power Indicator
will illumine (the “2” on the picture 5-5).
There are some difference between the laser machine user manual and laser
source use manual in the boot steps .Please follow the manual.Any
question ,please contact with our company .Please don’t change the operation
steps randomly.
D).Assist gas supply equipment: open the air supply valve required, check the
gas path of each filter equipment and pressure, The state of force table is normal.
Note: the water cooler may be modified, with its own independent specification
shall prevail; this manual is only for reference.
5.2 RAYCUS Optical fiber signal line connection method
Please refer the LF1390 FIBER LASER CUTTING MACHINE ELECTRICAL
DIAGRAM.
To Next Page
Loading...
