4. Operating System and Equipment
Turning on Front Win
dshield Washer System
- If the wiper combination switch lever is pulled
back (backward direction of the car) to position
⑥ , the front windshield washer system is
started; the washer jets water and a little later
the front wipers begin to work.
- If the wiper combination switch lever is
released to let it return to the original position,
the front windshield washer system is off and
the front wipers continue to work for about 4s.
– After a pause of 6 seconds, the front wipers
operate once to remove residual water stains
on the glass.
Maintenance of Front Wiper*
– Within 10 seconds after the Start or Ignition
switch from “ON” position switched to “OFF”
position, if the wiper combination switch lever
is pushed to MIST and then pulled back
rapidly, the front wipers will move to the
highest positions and then stop.
Hint
The “Maintenance of Front Wiper” function can
be enabled or disabled via "Car Setting" under the
audio system. => Refer to Page 204
To Next Page
Loading...
