5. Driving Guide
– Apply the
parking brake, put the shift lever into
“P” gear, and loosen the brake pedal.
– Stop the engine. => Refer to Page 276
– Take out the mechanical key, then turn the
steering wheel back and forth, and engage the
steering wheel lock mechanism (apply to
models with Ignition switch).
Caution
• To ensure safety, please ensure that the shift
lever is at the "P" or "N" position before
starting the engine, and do not start the engine
in other gears.
• Idle speed of cold engine is very high, so you
should drive your car only after the engine
idling is stable before the engine warming.
• Do not depress the accelerator pedal violently
when the car is still, which may result in high
load, damaging the engine.
• After the engine stop, the system will release a
warning beep if the shift lever is not switched
to “P” gear.
Driving Instructions for Vehicle Models wi
th
Manual Transmission
– Start the engine. => Refer to Page 274
– Put the shift lever from the neutral gear to "1"
gear, remove the parking brake, slowly loosen
the clutch pedal, to let the vehicle start to
move.
– Depress the accelerator pedal to accelerate,
put the shift lever to corresponding gear when
reaching a certain speed.
– Depress the brake pedal and clutch pedal to
stop the vehicle steadily;
To Next Page
Loading...
