5. Driving Guide
Apply
i
ng D
y
namic Emergency Brake
– The dynamic
emergency braking can be
realiz
ed by pulling up the EPB button ①
continuously in the driving process. If the
accelerator pedal is depressed in emergen
cy
braking process, the system will quit braking. If
the emergency braking is not triggered by
driver operation, please depress the
accelerator pedal repeatedly to quit braking.
Hint
Switch the Start or Ignition switch to "ON"
position. The corresponding indicator light
(red)
in the instrument cluster will be illuminated when
the EPB is applied. The indicator light
will be off
when the EPB is removed. In case of any of the
following phenomena, please apply and release the
EPB again. If the fault persists, please contact your
GAC MOTOR dealer for maintenance.
● If the indicator light
flashes in red
continuously, it indicates that the EPB is in
partial combination/ removal state or there is a
fault in the system.
• If the indicator light
lights up in red when
the EPB is not applied, the system is
abnormal.
• If the indicator light
(yellow) is on, it
indicates that a fault is detected in the EPB
system and the EPB performance decreases.
Caution
● Do not apply the dynamic emergency braking
when unnecessary, because the parking brake
only exerts power on the rear wheels, whic
h
can easily cause traffic accidents. In addition,
the braking distance is longer than that when
using the brake pedal, and it will short
en the
service life of the parking brake system.
• If the EPB button is pulled up during driving,
the buzzer will alarm and the instrument
cluster display will show "Release the EPB
switch".
• During the deceleration, the release state of
parking brake can be recovered by releasing
the EPB switch or depressing the accelerator
pedal. If the EPB system is continuously pulled
up until the vehicle is stopped, the parking
brake will remain in combination state.
To Next Page
