6. Usage and Maintenance
3. Rotate counter-clo
ckwise and take out the
brake light bulb ① from the brake light holder.
4.
Generally, perform the installation in the
reverse order of removal proce
dures
Replacing Rear Position Light
The rear position light and rear combination
light should be seen as an entirety. Only LED bulbs
are used. It's not allowed to replace any set of
LEDs separately in repair work. If one set of LEDs
are broken, more load will be applied to the other
intact LEDs, which will significantly shorten their
service life.
In case of any failure of the rear position light,
please have your vehicle checked and repaired at
GAC MOTOR dealer as soon as possible.
Replacing Reverse Light Bulb
1. Switch off the Start
or Ignition switch.
2. Open the trunk lid.
3.
Prise out the fixing plastic nails (see the
arrows) and open the trunk lid trimming.
To Next Page
Loading...
