GALaxy eHydro Elevator Controller Section 6 – Main CPU Faults & Detailed Faults
6-41
Table 6-0: Main CPU Faults
Possible Cause/Suggested Fix
APS (Absolute Position
System) Selector
Fault. This fault may
occur due to either an
internal error,
communications
error, position
validation error,
velocity validation
error on the APS
Selector.
• From the LCD user interface, select the Diagnostic menu
and then the Sel CAN Com Status menu. The Rx Error Cnt
should be zero and the Rx Data Cnt should be incrementing.
If the selector board is not communicating it will show with
the online status equal to 0. If the Rx Error Cnt is not zero,
there is most likely a connection problem from the COP to
the Main I/O board.• From the LCD user interface, verify
that the NTS processor is also communicating properly with
the APS Selector.• Possible solution is to clean the APS tape
with damp soft cloth.• Check the APS Camera and make
sure both LEDs on the camera are green. If not refer to the
installation procedure to adjust the camera alignment to the
tape.
Automatic Service
Time-out Car 1
• Car was not able to answer group hall call within the
automatic service time-out timer. Look for fault condition on
car.
Automatic Service
Time-out Car 2
• Car was not able to answer group hall call within the
automatic service time-out timer. Look for fault condition on
car.
Automatic Service
Time-out Car 3
• Car was not able to answer group hall call within the
automatic service time-out timer. Look for fault condition on
car.
Automatic Service
Time-out Car 4
• Car was not able to answer group hall call within the
automatic service time-out timer. Look for fault condition on
car.
Automatic Service
Time-out Car 5
• Car was not able to answer group hall call within the
automatic service time-out timer. Look for fault condition on
car.
Automatic Service
Time-out Car 6
• Car was not able to answer group hall call within the
automatic service time-out timer. Look for fault condition on
car.
Automatic Service
Time-out Car 7
• Car was not able to answer group hall call within the
automatic service time-out timer. Look for fault condition
on car.
Automatic Service
Time-out Car 8
• Car was not able to answer group hall call within the
automatic service time-out timer. Look for fault condition on
car.