Setting the Flush Time parameter:
1. Press the Forward key three times to move to the following screen:
The screen displays the current controller configuration: Program I, 4 filters, main valve, and delay
valve. The controller also displays the Flush Time icon.
The word SECin the digits line indicates that the flush time parameter is set in seconds.
2. Press the Plus or Minus keys to set the flush time value.
3. Press the Forward or the Backward keys to move to the next or previous screen accordingly.
The new Flush Time is activated when the next flush cycle starts.
Technician Mode
To enter into Technician mode: press and hold the Plus, Minus, and Manual keys for 5 seconds.
When in Technician mode for 60 seconds without any key pressed, the controller returns to regular
operation mode.
Selecting the filter type
30 AMCFlushing Controller User Guide
Setup and Operation
To Next Page
Loading...
