-
-
-26--26-
11.3. – INTAKE NOZZLE11.3. – INTAKE NOZZLE
The starters are delivered fitted with a The starters are delivered fitted with a standard connection nozzle (01) to which the air intake standard connection nozzle (01) to which the air intake tube (02) can betube (02) can be
welded which connects it with the tank welded which connects it with the tank (or with the (or with the correspondincorresponding intermediate elemeng intermediate elements, cutoff valve, ts, cutoff valve, flexibleflexible
pipe, filter or any pipe, filter or any other piece).other piece).
In the eveIn the event of nt of using iusing i t thit this way, the welding (03s way, the welding (03) must be airtight ) must be airtight and comply wand comply with tith thehe
corresponding regulations for pressure equipment (97/23/EC).corresponding regulations for pressure equipment (97/23/EC).
04
04
0101
0303
0505
0202
The nozzle has to be fixed tThe nozzle has to be fixed to the starter with o the starter with the four self-locking nuts (04) which the four self-locking nuts (04) which are supplied untighteneare supplied untightened. Dod. Do
not forget to insert not forget to insert the O-ring (05) which is the O-ring (05) which is provided between the nozzle and the starter. Assure the correctprovided between the nozzle and the starter. Assure the correct
assembly of the same and avoid it assembly of the same and avoid it being badly positionedbeing badly positioned, which would damage the same and mean loss of , which would damage the same and mean loss of air.air.
If, during the assembly, this gasket is If, during the assembly, this gasket is damaged it will be necessary to replace it damaged it will be necessary to replace it with a new identical one.with a new identical one.
11.4. – INTAKE FILTER AND INLET ELBOWS
11.4. – INTAKE FILTER AND INLET ELBOWS
Filters can be supplied to prevent dirt Filters can be supplied to prevent dirt entering the starter. These filters have a entering the starter. These filters have a mesh diameter of 0.6 mm, andmesh diameter of 0.6 mm, and
they come with a purging device. They can be supplied with or without coupling sleeves to the intake pipe.they come with a purging device. They can be supplied with or without coupling sleeves to the intake pipe.
Any type of elbow or Any type of elbow or pipe can be designed for specific applications.pipe can be designed for specific applications.
5804045
5804045
To Next Page
Loading...