Chapter 1 -- Safety Considerations--Defects and Abnormal Stresses
1 - 4
Defects and Abnormal Stresses
You should treat your Interface 1000 as potentially hazardous if any of the following is true of the unit:
• it shows visible damage,
• it does not operate properly,
• it has been stored for a long period of time under unfavorable conditions,
• it has been dropped or subjected to severe transport stress,
• it has been subjected to environmental stress (corrosive atmosphere, fire, etc.).
Do not use your Interface 1000 or any other apparatus if you think it could be hazardous. Have it checked
by qualified service personnel.
Environmental Limits
Note that there are environmental limit conditions on the storage, shipping and operation of this
equipment. The Interface 1000 has not been designed for outdoor use.
Storage
Ambient Temperature
-40 °C to 75 °C
Relative Humidity Maximum 90% non-condensing
Shipping Same as storage plus
Acceleration Maximum 30 G
Operation
Ambient Temperature
0 °C to 45 °C
Relative Humidity Maximum 90% non-condensing
Warning
The Interface 1000 is not designed for operation in conditions where liquid water
may enter the chassis, or water vapor may condense within the chassis. Operation of
an Interface 1000 that has water within the chassis can create a safety hazard, which
could result in personal injury or death.
Cleaning
Disconnect the Interface 1000 from all power sources prior to cleaning.
Use a cloth lightly dampened with either clean water or water containing a mild detergent to clean the
outside of the Interface 1000 enclosure. Alternatively, you can use isopropyl alcohol. Do not use a wet rag
or allow fluid to enter the Interface 1000 enclosure. Do not immerse the Interface 1000 in any type of
cleaning fluid (including water). Do not use any abrasive cleaners.
To Next Page
Loading...
