G&D DP-HR-CPU - Page 188

Configuration
183 · Computer and console modules (DP-HR)
Key combination for video switching of the DH-CPU
computer modules
When a user of a console with only one monitor connects to a computer with two
video outputs on a
DH-CPU computer module, the screen of the second video output
cannot be displayed.
To switch to the video signal from the second video output of the computer, the
Select Stream key combination is available for this application.
In the default setting you can switch between the video signal of the first and the sec-
ond video output of the computer with the key combination Alt+arrow right.
You can change the key combination in the hotkey menu.
How change the key combination for the Select Stream function:
1. Press the Alt+Num (default) hotkey to open the OSD.
2. Select Hotkey and press Enter.
3. Select Select stream and press F8 to select one of the following options:
4. Press F2 to save your settings.
NOTE: Use the Select Stream function on a dual monitor workstation (on a DH-CON
console module) to arrange the video signals from a computer with two video out-
puts (on a DH-CPU computer module) on the console monitors.
Each time you press the key combination Hotkey+arrow left or Hotkey+arrow right,
the arrangement switches in ascending or descending order as shown below:
 Video 1/Video 2
 Video 2/Video 1
 Video 1/Video 1
 Video 2/Video 2
Cursor left,right:
Video switching with Hotkey+arrow left or Hotkey+arrow right
(default)
Num+,Num-:
Video switching with Hotkey+Num+ or Hotkey+Num-