Gantner GAT NET.Lock 7000 - Restart a Controller GAT Net.controller S 7000 or GAT Net.controller M 7000; Delete Configuration Parameters of a Controller (= Reset to Default Settings)

GAT NET.Lock 7000 System
Configuration and Operation
32 HB_GAT-NETLOCK7000--EN_30 www.gantner.com
5.3 Restart a Controller GAT NET.Controller S 7000 or GAT NET.Controller M 7000
In certain situations (e.g. after an error or network problems) it may be helpful to restart a master or slave controller.
This means that the software application in these devices will be restarted.
To restart a controller, proceed with these steps (the picture above shows a slave controller):
- Press the RESET button for 5 seconds
-> LED 2 will blink red and green
- Release the RESET button
-> The slave controller restarts. This takes about 5 seconds. The configuration parameters will remain un-
changed.
5.4 Delete Configuration Parameters of a Controller (= Reset to Default Settings)
After deleting the configuration parameters of a controller (master or slave) the controller works identically as on the
time of delivery.
Attention, the reset of a controller must only be performed by an authorised service technician. After reset
the entire locker installation must be reconfigured via software.
To restart a controller, proceed with these steps (the picture above shows a slave controller):
- Press the RESET button for approx. 12 seconds.
-> LED 1 starts flashing blue.
- Within 3 seconds release the RESET button and press it again.
-> Configuration parameters are reset.
-> When resetting a slave controller the LEDs on the connected locks are blinging red/green.