m CAUTION
Since the choke (Fig. 18/arrow direction 1) is closed, the chain starts to move and
rotate AT HIGH SPEED, immediately the engine is started.
8. Let the engine run for 10 seconds to warm up. Press the safety throttle lock &
throttle lever briey, the engine will go to ‘idling’ speed (Fig. 20).
m CAUTION
Always pull the starter cable slowly (until you feel the initial resistance) before you
then pull it quickly to start the engine.
Do not allow the starter cable to whip back of its own accord.
If the engine does not start up even after several attempts, read the section
'Troubleshooting'.
Always pull out the starter cable in a straight line. If it is pulled out at an angle,
friction will occur on the eyelet.
As a result of this friction, the starter line will become frayed and will wear away
faster. Always hold the starter cable when the starter line retracts.
Starting the engine when warm
(The equipment has been idle for less than 15-20min)
Fill up the fuel tank with the relevant mixture of petrol and oil (Fig. 21), and also
top up the chain oil (Fig. 21). See the section 'Fuel and oil'.
Be certain the chain brake is disengaged before starting the unit (Fig. 11).
1. Make sure the stop switch is in the 'I' (ON) position (Fig. 19/right).
2. Set the equipment down on a rm level at surface. Hold the saw rmly as
shown. (Fig. 22) Beware of moving chain!
3. Pull the starter rapidly 6 times (Fig. 22/pos. 7 & Fig. 27). The engine should
start. If the equipment does not start after 6 tugs, repeat steps 1-6 of the
procedure for starting the engine from cold.
Each time before use, check the following:
- That there are no leaks in the fuel system.
AFTER SALES SUPPORT
39
00800 4003 4003
aldi.service.uk@scheppach.com
MODEL: CSP41 PRODUCT CODE: 64055 04/2017
Petrol chainsaw 41cc Operation
To Next Page
Loading...
