Tighten the clips for the cover (Fig. 16/pos. H).
Fuel Filter
m NOTICE
Never use the saw without a fuel lter. After 100 hours in operation the fuel lter
should be cleaned or, in case of damage, replaced. Be sure to empty the fuel tank
before changing the lter.
1. Ensure the Stop switch is set to Stop (0).
2. Remove the top cover & disconnect the spark plug boot.
3. Remove the fuel tank cap (Fig. 21/pos. K).
4. Bend a piece of soft wire.
5. Reach into the fuel tank opening and hook the fuel line. Carefully pull the fuel
line toward the opening until you can reach it with your ngers.
m NOTICE
Do not pull hose completely out of tank.
6. Lift the lter out of tank.
7. Pull the lter off the fuel pipe with a twist and clean it. (If the lter is damaged,
dispose of it and replace it with a new lter).
8. Insert the end of the cleaned /new lter onto the fuel pipe. Place one end of the
lter into the tank opening. Make sure that the lter is seated in the lower corner
of the tank. If necessary, use a long screwdriver to move the lter to its correct
position, taking care not to damage it in the process.
9. Fill tank with fresh fuel / oil mixture. See the Section Fuel and Lubrication.
Securely ret the fuel tank cap.
Spark plug (Fig. 24b)
m NOTICE
To ensure that the saw's engine retains its power, the spark plug must be clean
and have the correct electrode gap (0.6 mm). The spark plug must be cleaned or
replaced after every 20 hours of service.
1. Set the Stop switch to Stop (0).
Maintenance and servicing Petrol chainsaw 41cc
44
AFTER SALES SUPPORT
aldi.service.uk@scheppach.com
00800 4003 4003
MODEL: CSP41 PRODUCT CODE: 64055 04/2017
To Next Page
Loading...
