Breaking in a new saw chain
A new chain and bar will need chain readjustment after as few as 5 cuts. This is
normal during the break-in period, and the interval between future adjustments will
begin to lengthen quickly.
m CAUTION
Never have more than 3 links removed from a loop of chain.
This could cause damage to the sprocket.
Chain lubrication
Always make sure the automatic oiler system is working properly.
Keep the oil tank lled with Chain, Bar and Sprocket Oil.
Adequate lubrication of the bar and chain during cutting operations is essential to
minimize friction with the guide bar.
Never starve the bar and chain of lubricating oil. Running the saw dry or with too
little oil will decrease cutting efciency, shorten saw chain life, cause rapid dulling of
chain, and lead to excessive wear of bar from overheating.
Too little oil is evidenced by smoke or bar discolouration.
m NOTICE
Store the equipment in a dry place and far away from possible ignition sources such
as an oven, a gas-red hot water boiler, a gas-red dryer, etc.
X. TECHNICAL DATA
Engine displacement 41 cm³
Maximum engine capacity 1.5 kW
Cutting length 37. 5 c m
Cutter rail length 16” (40 cm)
Chain pitch (3/8”), 9.525 mm
Chain thickness (0.05”), 1.27 mm
Idling speed 3300 ± 300 rpm
Maximum cutting speed 21 m/s
Maximum speed with cutting equipment 11000 rpm
AFTER SALES SUPPORT
49
00800 4003 4003
aldi.service.uk@scheppach.com
MODEL: CSP41 PRODUCT CODE: 64055 04/2017
Petrol chainsaw 41cc Maintenance and servicing/Technicl data
To Next Page
Loading...
