Gardenline CSP41 - Maintenance and Servicing Overview; General Cleaning Work; Chain Brake Operational Test

Carrying out any cleaning work
- The equipment should be cleaned thoroughly every time after it has been used.
This applies particularly to the chain and bar.
- Keep the air vents and the motor housing free of dirt and dust as far as possible.
Wipe the equipment with a clean damp cloth or blow it down with compressed air
at low pressure.
- It is easiest to remove sawdust and wood chippings immediately after use.
- Clean the equipment regularly with a damp cloth and some soft soap. Do not use
cleaning agents or solvents; these may be aggressive to the plastic parts in the
equipment. Ensure that no water can get into the interior of the equipment.
IX. MAINTENANCE AND SERVICING
MAINTENANCE
m CAUTION
All maintenance work on the chainsaw apart from the work described in this manual
may only be carried out by authorised after-sales service personnel.
Chain brake operational test
Test the chain brake periodically to ensure proper function. Perform a chain brake
test prior to initial cutting, following extensive cutting, and denitely following any
Chain brake service.
Test chain brake as follows:
1. Place saw on a clear, rm, at surface.
2. Start the engine.
3. Grasp the rear handle with your right hand.
4. With your left hand, hold the front handle (Fig. 1/pos. 6) (not chain brake lever)
(Fig. 1/pos. 5) rmly.
5. Squeeze the throttle trigger to 1/3 throttle, then immediately activate the chain
brake lever (Fig. 10/arrow direction 1).
m CAUTION
Activate the chain brake slowly and deliberately. Keep the chain from touching
anything, don't let the saw tip forward.
42
AFTER SALES SUPPORT
 aldi.service.uk@scheppach.com
 00800 4003 4003
MODEL: CSP41 PRODUCT CODE: 64055 04/2017
Cleaning/Maintenance and servicing Petrol chainsaw 41cc