6. Chain should stop abruptly. When it does, immediately release the throttle
trigger.
m CAUTION
If chain does not stop, turn engine off and take your unit to the nearest Authorized
Service Centre for service.
7. If the chain brake functions properly, turn the engine off and return the chain
brake to the DISENGAGED position.
Air Filter
m NOTICE
Never operate the saw without the air lter. Dust and dirt will be drawn into the
engine and damage it. Keep the air lter clean! The air lter must be cleaned or
replaced after every 20 hours of service.
Maintenance and ordering of spare parts
Always switch off the equipment and disconnect the spark plug boot (Fig. 15/pos. D)
before carrying out any maintenance work.
Cleaning the air lter (Fig. 21A/21B)
1. Ensure the Stop switch is set to Stop (0).
2. Remove the top cover (Fig. 12/pos. 9) by removing the clips on the cover as
shown in gure 12. You can then remove the cover (Fig. 13/pos. 9).
3. Disconnect the spark plug boot (Fig. 15/pos. D) from the spark plug (E) by pull-
ing and twisting it simultaneously (Fig. 15).
4. Remove the air lter fastening knob (Fig. 15/pos. G) by turning counterclock-
wise.
5. Lift out the air lter (Fig. 15/pos. F).
6. Clean the air lter. Wash the lter in clean, warm, soapy water.
Rinse in clear, cool water Air dry completely before retting.
It is advisable to have a supply of spare lters.
7. Insert the air lter. Turn the air lter fastening knob clockwise to secure the air
lter. Ret the top cover for the engine / air lter (Fig. 16/pos. 9). Make sure that
the cover ts perfectly when you do so.
AFTER SALES SUPPORT
43
00800 4003 4003
aldi.service.uk@scheppach.com
MODEL: CSP41 PRODUCT CODE: 64055 04/2017
Petrol chainsaw 41cc Maintenance and servicing
To Next Page
Loading...
