13-20-604 Page 21
Unit Hot (No warm-up period is required):
1. Open the air service valve (customer furnished) between the main air system and the check valve on
the package.
2. Run for approximately one minute. The unit is equipped with a minimum (70 psig) pressure/check
valve, no special procedure to maintain the unit reservoir pressure is required.
DAILY CHECK - Refer to “Maintenance Schedule,” SECTION 8, page 52.
STOPPING THE UNIT:
1. To stop compressor operation, press STOP/RESET.
2. Wait approximately one minute to allow the compressor to stop. The oil reservoir will automatically
blow down as the motor stops.
To Next Page
Loading...
