13-20-604 Page 41
8. Machine should then be run normally; however, total run time after the initial change outs should be
50 percent of normal anticipated service life of the new lubricant.
• Drain all lubricant from system, change filter and separator, and replace with full charge of the
new lubricant.
9. Subsequent lubricant change outs should be at normal intervals. See ”Oil Change Interval”, Figure 5-
3, page 37.
Material Safety Data Sheets (MSDS) are available for all AEON lubricants from your authorized Gardner
Denver distributor or by calling (217) 222-5400.
To Next Page
Loading...
