Garmin G1000 Pilot’s Guide for the Piper PA-32 Saratoga
190-02692-00 Rev. A234
FLIGHT MANAGEMENT
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICESINDEX
2) To select another airport, push the FMS Knob to activate the cursor, enter an identifier/facility name/city, and
press the ENT Key.
3) Turn the large FMS Knob to highlight the procedure. The procedure is previewed on the map.
4) Turn the small FMS Knob to view the available procedures. Press the ENT Key to select the procedure. The
cursor moves to the next box (runway or transition). The procedure is previewed on the map.
5) Turn the small FMS Knob to view the available runway or transition. Press the ENT Key to select the runway or
transition. The cursor moves to the next box (if available). The procedure is previewed on the map.
6) Repeat Step 5, until desired information has been viewed for the chosen procedure.
7) Press the INFO-1 or INFO-2 Softkey to return to the WPT – AIRPORT INFORMATION PAGE.
DEPARTURES
A Departure Procedure (DP) is loaded at the departure airport in the flight plan. Only one departure can be
loaded at a time in a flight plan. If a departure is loaded when another departure is already in the active flight
plan, the new departure replaces the previous departure. The route is defined by selection of a departure, the
transition waypoints, and a runway.
Loading a departure into the active flight plan using the PROC Key:
1) Press the PROC Key. The PROCEDURES Window is displayed.
2) Highlight SELECT DEPARTURE.
3) Press the ENT Key. The PROC – DEPARTURE LOADING Page is displayed.
4) Use the FMS Knob to select an airport and press the ENT Key.
5) Select a departure from the list and press the ENT Key.
6) Select a runway (if required) and press the ENT Key.
7) Select a transition (if required) and press the ENT Key. LOAD? is highlighted.
8) Press the ENT Key to load the departure procedure.
To Next Page
Loading...
Need help?
General
