Garmin GPSMAP 5215 - Waypoints and Routes on the Radar Screen

72 GPSMAP
®
4000/5000 Series Owner’s Manual
Radar
Waypoints and Routes on the Radar Screen
Marking a Waypoint on the Radar Screen
1. From the Home screen, select .
2. Select a radar mode.
3. Select a location
4. Select .
Showing or Hiding Waypoints on the Radar Screen
You can show waypoints that are within the range shown on the Radar screen. This setting does not apply to
the Radar Overlay.
1. From the Home screen, select  >  >  > .
2. Complete an action:
• Select  to show all waypoints.
• Select  to show only waypoints associated with the currently active route.
• Select  to hide all waypoints.
Navigating a Saved Route on the Radar Screen
Before you can browse a list of routes and navigate to one of them, you must record and save at least one route
(page 33). Navigation lines must be showing in order to view a route on the Radar screen (page 82).
1. From the Home screen, select  > .
2. Select a route.
3. Select .
4. Complete an action:
• Select  to navigate the route from the starting point used when the route was created.
• Select  to navigate the route from the destination point used when the route was created.
5. From the Home screen, select .
6. Select , , , , or .
The route appears as a magenta line, with the starting point, destination, and turns indicated.
7. Review the course indicated by the magenta line.
8. Follow the magenta line along each leg in the route, steering to avoid land, shallow water, and other
obstacles.
Navigating Parallel to a Saved Route on the Radar Screen
Before you can browse a list of routes and navigate to one of them, you must record and save at least one route
(page 33). Navigation lines must be showing in order to view a route on the Radar screen (page 82).
1. From the Home screen, select  > .
2. Select a route.
3. Select .
4. Select  to navigate parallel to the route, offset from it by a specic distance.
5. Select .
6. Enter the offset distance.
7. Select .
8. Complete an action:
• Select  to navigate the route from the starting point used when the route was created, to
the left of the original route.
• Select  to navigate the route from the starting point used when the route was
created, to the right of the original route.
• Select  to navigate the route from the destination point used when the route was
created, to the left of the original route.