Viewing Information
GPSMAP 400/500 Series Owner’s Manual 39
3. Complete one of the following:
• Select to transfer data from the SD card to the
chartplotter and combine it with existing user data.
• Select to overwrite items on your chartplotter.
4. Select the le name from the list. The data is transferred from the SD card
to the chartplotter.
1. Insert an SD card (at least 4 GB) into the SD card slot on the front of the
unit.
2. From the Home screen, select > >
> to copy the maps loaded onto your chartplotter to
the SD card.
1. Connect the unit to a NMEA 2000 network. Refer to the GPSMAP 400/500
Installation Instructions.
Only the following units are NMEA 2000 compatible:
• GPSMAP 441/441s
• GPSMAP 536/536s
• GPSMAP 541/541s
• GPSMAP 546/546s
2. From the Home screen, select > >
> .
3. Complete one of the following:
• Select to transfer waypoints, routes, and tracks
to other chartplotters connected to the network. Existing data is
overwritten on those chartplotters.
• Select to transfer data between all the chartplotters
connected to the network. Unique data is combined with existing data
on every chartplotter.
1. Insert an SD card into the SD card slot on the front of the unit.
2. From the Home screen, select > >
> .
3. Complete one of the following:
• Select the le name from the list.
• Select to create a new le. Enter the le name using the
, and press .
4. Remove the SD card from the unit, and insert it into an SD card reader
attached to a computer.
5. From Windows
®
Explorer, open the Garmin\UserData folder on the SD
card.
6. Copy the appropriate .ADM le on the card, and paste it to any location on
the computer.
To Next Page
Loading...
