Garmin INSTINCT 2X - Changing the Spring Bar Bands; Data Management

Changing the Spring Bar Bands
You can replace the bands with new Instinct 2 bands or compatible QuickFit
®
22 bands.
1 Use the pin tool to push in the watch pin.
2 Remove the band from the watch.
3 Select an option:
• To install Instinct 2 bands, align one side of the new band with the holes on the watch, push in the
exposed watch pin, and press the band into place.
NOTE: Make sure the band is secure. The watch pin should align with the holes on the watch.
• To install QuickFit 22 bands, remove the watch pin from the Instinct 2 band, replace the watch pin on the
watch, and press the new band into place.
NOTE: Make sure the band is secure. The latch should close over the watch pin.
4 Repeat the steps to change the other band.
Data Management
NOTE: The device is not compatible with Windows
®
95, 98, Me, Windows NT
®
, and Mac
®
OS 10.3 and earlier.
Device Information 95