Gate Titan - Page 20

20
 Settings tab:
Fire selector mode – allows you to choose how your replica will behave on each re selector
position:
• SAFE – replica will not re aer trigger pull
• SEMI – one pull of the trigger will result in only one shot
• BURST – one pull of the trigger enables you to shoot a pre-determined
number of BBs, which is very useful in MILSLIM and when using low-caps
• AUTO – pulling the trigger causes uninterrupted* series
of shots until the trigger is released
*series can be limited by Round Limit
Pre-cocking mode – allows for initial spring compression, which speeds up the trigger
response signicantly:
• AUTO MODE – the spring is automatically compressed aer each shot
• TRIGGER MODE – slow trigger action compresses the
spring, and fast trigger action res the shot
Please note: using PRE-COCKING increases wear and tear on the gearbox.
Pre-cocking boost – determines the strength of spring compression. The highest setting
results in the best trigger response, but also mostly increases wear and tear on the gearbox.
If you are facing overspin issue, set GEAR RATIO to HIGH SPEED.
Burst mode:
• FULL – every, even the shortest trigger action res the pre-determined number of
rounds
• TRIGGER – releasing the trigger while ring stops the burst sequence.
Burst – allows you to set how many BBs will be red
ROF stabilization:
• ON – ROF Control uses PWM (Pulse Width Modulation) to decrease ROF. Thanks to this,
gearbox works smoothly what decreases wear and tear of AEG internal parts. The
percentage value determines the PWM duty cycle and it does not reect ROF decrease.
• OFF – ROF Control adds breaks between shots to decrease ROF. It gives you more
realistic experience. This option set to 50% will signicantly reduce the rate of re.
ROF control – enables a reduction in a gun’s rate of re. You use stronger LiPo batteries, and
still have a ROF just like in a real gun.
Sniper delay – lets you to set delay between each SEMI shots to simulate the delay from reload
or recoil. You can set 0.5s, 1s, 2s or 3s delay. By choosing ‘VIB’ option, you can enable vibration
which will inform you when the gun is ready to re again.