EasyManuals Logo

Gate Titan User Manual

Gate Titan
101 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #97 background imageLoading...
Page #97 background image
97
ROF STAB
It allows you to change the way the ROF Control works:
ON - ROF Control uses PWM (Pulse Width Modulation) to decrease ROF. Thanks to
this, gearbox works smoothly what decreases wear and tear of AEG internal parts.
OFF - ROF Control adds breaks between shots to decrease
ROF. It gives you more realistic experience.
SNIPER DELAY
It lets you to set delay between each SEMI shot to simulate the delay from reload or recoil.
You can set 0.5s, 1s, 2s or 3s delay. You can enable vibration which will inform you when the
gun is ready to shoot again by choosing “VIB” option.
SMART TRIGGER
We know how vital the fast trigger response is during combat. This is why we have developed
the Smart Trigger function. It enables you to achieve a faster trigger response. It works
with the ROF Control System. During the rst shot, the microprocessor sets the ROF Control
to 100%. Aer the rst shot, it switches to a previously programmed value (e.g. 50%). As
a consequence, the rst shot is red at a full ROF, and subsequent shots at a reduced ROF.
The best results can be achieved by using a battery with a higher than standard voltage. For
example, if you use a 7.4V battery, you can replace it with 11.1V. In this way, you will achieve a
faster trigger response with the same rate of re as with a standard battery.
*Works only when ROF STAB is ON.
TWO STAGE TRIGGER
Enjoy two stage trigger. Activate 2-STAGE trigger mode and set two dierent trigger
sensitivities. Pulling the trigger slightly produces SEMI or BURST re and pulling the trigger
further produces BURST or AUTO re (depending on the re selector mode).
BATTERY PROTECTION (gen.2*)
Protection against over-discharge of the battery. Modern LiPo and LiFe batteries are very
sensitive to over-discharge. If you do not want to damage the battery and you care about
its service life, this protection is indispensable. The microprocessor monitors the battery
voltage constantly. When the voltage drops down to a critical level, it will not allow ring.
*TITAN detects the number of cells automatically. There is no need to reprogram TITAN every
time you replace the battery.

Other manuals for Gate Titan

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Gate Titan and is the answer not in the manual?

Gate Titan Specifications

General IconGeneral
MOSFETYes
Battery protectionYes
Trigger sensitivity adjustmentYes
Pre-cockingYes
ROF controlYes
Active brakeYes
Diagnostic systemYes
ProgrammableYes
Cycle DetectionYes
CompatibilityV2 Gearbox
Low current consumption in sleep mode0.2mA
ConnectivityUSB-Link, Blu-Link
Fire ModesSemi, Burst
Bluetooth supportYes

Related product manuals