68 Maintaining and Troubleshooting Your E-3200 System
Keyboard clock line
failure.
Try a working keyboard.
Make certain the keyboard is compatible
with the system. You may have to change
the switch setting to AT.
Keyboard controller
failure.
Try a working keyboard.
Make certain the keyboard is compatible
with the system. You may have to change
the switch setting to AT.
Keyboard controller
failure.
Try a working keyboard.
Make certain the keyboard is compatible
with the system. You may have to change
the switch setting to AT.
Keyboard not detected. See “The keyboard does not work.” on
page 61.
Turn off the system and check the keyboard
cable.
Keyboard stuck key
failure.
Remove any objects that may be resting on
the keyboard, and then restart the system.
Check for sticky keys. Clean the keyboard if
necessary.
Memory errors were
detected while the
system powered up.
See “Memory errors were detected during
system start up.” on page 55.
Memory size error. Enter Setup utility and save the memory
configuration.
Non-system disk or disk
error.
Eject the diskette and press
E
NTER
.
If the diskette is bootable, check it for
errors.
Not enough memory. Close all programs that are not currently in
use.
Print queue is full. Wait until the current print job has
completed before sending another print job.
If you receive this error often, you need to
add memory to the printer.
Printer is out of paper. Add paper to the printer.
Make certain the printer is online.
Error Message Solutions
To Next Page
Loading...
Need help?
General
