47
232001240G(08)
The Other Page allows you to change various settings relating to the control panel. The Language setting will
allow changing available languages displayed by the control panel. The Unit setting will allow you to chance
whether the units displayed by the control panel is in the metric or imperial system. The EOF (end of file) Alarm
setting will enable or disable an audible notification when your jobs are complete. The Air Delay setting allows
you to specify the delay in seconds of the SmartAIR air-assist after the point of laser firing.
Language: ENGLISH (others dependent on Firmware)
Unit: METRIC / ENGLISH
EOF Alarm: YES / NO
Air Delay: 1-100 seconds
TIP
Depending on the material you are working with, your laser settings, and the desired
results, please experiment with the air delay to achieve your desired results.
Directional
Adjust the value for that selection
Start / Stop Back to Main Work Page
Auto Focus Initiate the auto focus function
To Next Page
Loading...
