CS250 User Manual
14
If a piece of equipment has been tampered with, the trouble and status LEDs flash and the LCD displays the problem. You can inhibit a tamper to
arm the system.
1 Enter the user code. ..........
2 Press the down arrow. ................................................................
3 Press OK. ....................................................................................
4 Press the down arrow twice........................................................
5 Press OK. Any inhibited tamper zones are displayed. ................
6 Enter the code for the system tamper that you want
to inhibit followed by #. The inhibit is displayed. In this
example, the internal bell tamper is inhibited. .............................
INHIBITING A SYSTEM TAMPER
User Menu
Arm Options
User Menu
Inhibits
Inhibits
Inhibit Zone
Enter Code
****
Inhibits
Inhibit Sys Tam
Inhibit Sys Tam
None
Inhibit Sys Tam
Internal Bell
System Tamper Codes
Explanations for these can be found
in the service messages.
Code Tamper
1 Ext Tamp
2 Local Tamp
3 Int Bell Tamp
4 Ext Bell Tamp
5 - 12 Keypad Tamp 1-8
13 Bus Tamp
14 EXPN Lid Tamp
15 RF Jam Tamp 1
16 RF Ant Tamp 1
17 EXPN Lid Tamp 2
18 RF Jam Tamp 2
19 RF Ant Tamp 1
To Next Page
Loading...
Need help?
General
