CS250 User Manual
16
DURESS ARM/DISARM
If the system is armed, entering the duress code disarms the system. If there is a communicator installed, a message is sent to the ARC to report that the
system is being disarmed under duress. No indication of an alarm or report is shown on the keypad or anywhere on the premises. If the system is
disarmed, entering the code arms the system. If a communicator is installed, a message is sent to the ARC.
1 Enter the duress code. ................................................................
2 The system disarms and immediately reports
a duress alarm to the ARC, if a communicator is installed.........
Thu 12 Feb 10:12
Area 1 Disarmed
Enter Code
****
To Next Page
Loading...