CS250 User Manual
30
SERVICE MESSAGES
MESSAGE WHY ACTION
Low Power The standby battery for the control panel is extremely low. Connect the mains power to the contol
panel and allow the battery to recharge.
Mains Fault The mains power supply to the control panel is not working Reconnect the power supply and ensure it
properly. is working properly.
Output 3 There has been interference with a zone linked to Output 3. Check the connection. If there is damage or it
This is generally a fire zone. is not connected properly, contact the installer.
Pd Low Battery The battery in a wireless sensor is low. Replace the battery in the wireless sensor.
RAM Error The control panel memory is not working properly. Contact the installer.
RF Ant Tamp There has been interference with the antenna of the wireless Check the antenna. If there is damage, contact
receiver. the installer.
RF EP Jam Fault A signal is blocking communication between the control panel Contact the installer.
and a wireless device.
RF Jam Tamp A signal is blocking communication between the control panel Contact the installer.
and a wireless device.
RF Sen Sup Loss A wireless sensor is not reporting to the control panel. Replace the wireless sensor battery. If the
condition continues, contact the installer.
RF Supv Late A wireless sensor has not reported to the control panel. Open and close the specified zone and try
to arm the system again. If the condition is
persistent, contact the installer.
ROM Error The control panel memory is not working properly. Contact the installer.
Sensor Main Req The fire detector is dirty. Contact the installer to clean the fire detector.
To Next Page
Loading...
Need help?
General
