8.2.7 Gate Drive Card
1. Disconnect cables from gate drive card connectors MK100, MK102, MK103, MK104, MK106, and, if unit has a brake option MK105.
2. Remove gate drive card by removing 6 mounting screws (T25) from standoffs.
Reinstall in reverse order of this procedure. Tighten mounting screws to 2.3 Nm (20 in-lbs).
1
2
34 5
6
130BX256.10
1 MK104 (W) 4 MK100
2 MK103 (V) 5 MK105 (brake option)
3 MK102 (U) 6 MK106
High Power Service Manual for Unit Sizes 6x
115
8
To Next Page
Loading...
