9.2.9 Diode Module
1. Remove power card mounting plate in accordance with instructions.
2. Remove soft charge mounting plate in accordance with instructions.
3. Remove two mounting nuts (17mm) from diode module, one on AC input side and one on (-)DC side of module.
4. Remove diode module by removing four retaining screws (T30) and washers from corners of module.
Reassembly
1. Replace diode module in accordance with instructions included with replacement module.
2. Reassemble in reverse order of this procedure.
1
2
3
1 17mm retaining nut (step 3) 3 Diode module
2 T30 screws (step 4)
High Power Service Manual for Unit Sizes 6x
128
9
To Next Page
Loading...
