GE Amersham Typhoon - Preparing a Sample for Fluorescence Imaging

6.2.1 Preparing a sample for fluorescence imaging
Introduction
This section describes how to prepare a fluorescent sample for scanning.
Prepare a gel or membrane for
fluorescence imaging
Follow the steps below to prepare a gel or membrane sample for fluorescence imaging.
ActionStep
Place a gel or membrane on the fluor stage.1
Remove any air bubbles between the gel or membrane and the stage.2
104 Amersham Typhoon Operating Instructions 29193226 AC
6 Operation
6.2 Preparing the sample
6.2.1 Preparing a sample for fluorescence imaging