GE APEL70 User Manual

Using the dehumidifier.
Always make sure the water bucket is locked into place on the dehumidifier.
Removing Collected Water
Thereare 2 ways to remove collected water:
F] Usethe bucket. When the bucket is removed, the unit
will shut off. Emptyand replace the bucket.
NOTE: Support bucket with
both hands when emptying.
%
%
IMPORTANT:Do not usethe hoseif using the bucket
to collectwater. When the hose is connected, water
will flow through it onto the floor instead of into the
bucket.
NOTES:
[] Donot remove the bucket while the dehumidifier
isoperating or if it has just stopped operating. This
might cause some water to drip from the drain
pan.
[] The bucket must be in place and securely seated
for the dehumidifier to operate.
Usea hose. Water can be automatically emptied into
a floor drain by attaching a garden water hose (not
included).
1. Removethe bucket from the front of the unit.
2.Open the drain cover on the sideof the unit.
21.Thread a garden hose (not supplied) onto the
nozzle,cut to length, and lead it to the floor drain.
4. Replacethe bucket in the unit.
NOTE:The bucket must be in place and securely
seated for the dehumidifier to operate.
Usethe internal pump. Water can be automatically
emptied into a remote location by attaching the
included pump hose.
L Attach the pump hoseto the hose connector by
pushing the tube fitting into the connector until it
fits into place(should not be able to remove the
hosewhen pulled).
2. Positionthe hosedischarge to the desired location.
3. Hake sure the pump is activated. To activate the
pump, pressand hold the PumpOn/Off button for
3 seconds.The Internal Pump On indicator light will
flash then remain illuminated once the 3 seconds
are complete.
IMPORTANT:Hake sure the condensate hose is
properly connected and isnot kinked, bent or cracked
as this may cause water to flow onto the floor. The
bucket must also befully seated for the pump to work
properly. Do not operate the machine if the room
temperature is32For below.
NOTES:
[] Haximum lift height is 16ft
[] Thebucket must be in place and securely seated
for the dehumidifier and pump to operate.
Hake sureto install hose (included)before activating
the pump.
Install hose at connector
on backside of machine
\
To InstallHose: Push in hose and gently pullto make
sureit is secure.
Push h_osein
To ReleaseHose: Holdthe grey ring while puling to
remove
1.Hold grey ring in
t
2. Pull hose out
\
CORRECT
DONOTkink or crimp hose,
as it can block water flow.

GE APEL70 Specifications

General

Brand	GE
Model	APEL70
Category	Dehumidifier
Language	English