Using the clock and timer. GEAppliances.com
Not all features are on all models.
Make sure the clock is set to the
correct time of day.
To Set the Clock
Theclock must be set to the correct time of day
for the automatic oven timing functions to work
properly.Thetime of day cannot be changed
during u timed baking or self-cleaning cycle.
[Z] Touch the CLOCKpad.
[] Touch the number pads.
Touch the number padsthe same way you
read them. Forexample, to set 12:34,touch the
number pads1, 2,3 and 4 in that order.
If number padsare not touched within one
minute after you touch the CLOCKpad,the
display revertsto the original setting. Ifthis
happens, touch the CLOCKpad and reenter
the time of day.
[] Touch the STARTpad until the time of day
shows in the display.Thisenters the time
and starts the clock.
Tocheck the time of day when thedisplay is
showing other information, simply touch the
CLOCKpad. Thetime of day shows until another
pad istouched.
®®®®®
®®®®®
The timer is a minute timer only.
The CLEAR/OFFpad does not affect
the timer.
To Set the Timer
Thetimer does not control oven operations.
The maximum setting on the timer is9 hours
and 59 minutes.
Touch the KITCHENTIMERON/OFF pad.
Touch the number pads until the amount
of time you want shows in the display.The
maximum number of minutes that can be
entered is 60.To set additional time, you
will need to set it by hours and minutes.
Forexample, to enter 1 hour and 30
minutes, touch 1,3 and 0 in that order.
Ifyou make a mistake,pressthe KITCHEN
TIMERON/OFFpad and begin again.
@
Touch the STARTpad. After pressing the
STARTpad, SETdisappears; this tellsyou
the time is counting down, although the
display does not change until one minute
has passed.
%
When the timer reaches :00, the control
will beep 3 times followed by one beep
every 6 seconds until the KITCHENTIMER
ON/OFFpad istouched.
The6-secondtone can becanceled by following
thesteps in theSpecial features
ofyour upper oven control section under Tones
at the Endof a TimedCycle.
To Reset the Timer
Ifthe display isstill showing the time remaining,
you may change it by touching the KITCHEN
TIMERON/OFF pad; then touch the number
pads untilthe time you want appears in the
display.
Ifthe remaining time isnot in the display
(clock,delay start or cooking time are in the
display),recall the remaining time by touching
the KITCHENTIMERON/OFF pad and then
touching the number pads to enter the new
time you want.
To Cancel the Timer
Touch the KITCHENTIMERON/OFF pad twice.
Power Outage
I1:aflashing time is in the display,you have
experienceda power failure. Resetthe clock.
Toreset the clock,touch the CLOCKpad.
Enterthe correct time of day by touching the
appropriate number pads.Touch the START
pad.
17
To Next Page
Loading...
