Cleaning the glass cooktop. GEAppliances.com
I
I
Clean your cooktop after
each spill. Use CERAMA
BRYTE®Ceramic Cooktop
Cleaner.
Normal Daily Use Cleaning
ONLYuse CERAMABRYTE®Ceramic Cooktop
Cleaneron the glass cooktop. Other creams
may not be as effective.
Tomaintain and protect the surface of your
glass cooktop, follow these steps:
[Z] Beforeusing the cooktop for the first time,
clean it with CERAMABRVTE®Ceramic
Cooktop Cleaner.Thishelps protect the
top and makes cleanup easier.
[] Daily use of CERAMABRYTE®Ceramic
Cooktop Cleanerwill help keep
the cooktop looking new.
r_ Shakethe cleaning cream well. Apply
a few drops of CERAMABRYTE®Ceramic
Cooktop Cleanerdirectly to the cooktop.
r_ use a paper towel or CERAMABRYTE®
Cleaning Padfor Ceramic Cooktops
to clean the entire cooktop surface.
r_ use a dry cloth or paper towel
to remove all cleaning residue.
No need to rinse.
NOTE: It is very important that you DO NOT
heat the cooktop until it has been cleaned
thoroughly.
Use a CERAMA BRYTE®Cleaning
Pad for Ceramic Cooktops.
Burned-On Residue
A CAUTION: OAMAG toyour
glass surface may occur ifyou use scrub
pads other than those recommended.
r-f] Allow the cooktop to cool.
r2] spread a few drops of CERAiVlABRVTE®
CeramicCooktop Cleaner on the entire
burned residue area.
[]
Using the included CERAMABRYTE®
Cleaning Padfor Ceramic Cooktops,rub
the residue area, applying pressure as
needed.
%
@
If any residue remains, repeat
the steps listed above as needed.
For additional protection, after all
residue has been removed, polish
the entire surface with CERAiVlABRYTE®
CeramicCooktop Cleaner
and a paper towel.
The CERAMABRYTE®Ceramic
Cooktop Scraper and all
recommended supplies are
available through our Parts
Center. See instructions under "To
Order Parts" section on next page.
NOTE: Do not use a dull or nicked
blade.
Heavy, Burned-On Residue
F71
Allow the cooktop to cool.
Use a single-edge razor blade scraper
at approximately a 45 ° angle against
the glass surface and scrape the soil. It
will be necessary to apply pressure to
the razor scraper in order to remove the
residue.
@
After scraping with the razor scraper,
spread a few drops of CERAIVlABRYTE®
CeramicCooktop Cleaner on the entire
burned residue area. Use the CERAIVlA
BRYTE®Cleaning Pad to remove any
remaining residue.
%
For additional protection, after all
residue has been removed, polish
the entire surface with CERAiVlABRYTE®
CeramicCooktop Cleaner
and a paper towel.
37
To Next Page
Loading...
