GEAppliances.com
Possible Causes What To Do
"F--"and a number or You have a function error code. . Touch the CLEAR/OFFpad.Allow the oven to cool for
letter flash in the display one hour. Putthe oven back into operation.
If the function code repeats. . Disconnectall power to the range for 5 minutes
and then reconnect power. Ifthe function error code
repeats,call for service.
"Probe" appears in This is reminding you to enter . Entera probe temperature.
the display a probe temperature after
plugging in the probe.
Display goes blank A fuse in your home may be • Replace the fuse or reset the circuit breaker.
tripped,blown or the circuit breaker
The clock is in the . See the Special features ofyour upper oven control section.
black-out mode.
Display flashes Power failure. . Reset the clock.
Unable to get the Oven control pads were . The BAKEand BROILHI/LO pads must be touched at
display to show "SF" not pressed properly, the same time and held for 3 seconds.
Power outege__ Power outage or surge. . Resetthe clock. Ifthe oven was in use,you must reset
clock flushes it by touching the CLEAR/OFFpad, setting the clock
and resetting any cooking function.
s, B " as ,1 " _,
urnmg or only This is normal in a new oven . Tospeed the process,set a self-clean cycle for a
odor emitting from and will disappear in time. minimum of 3 hours. Seethe Using the self-cleaning
the vent upper oven section.
Strong odor An odor from the insulation . Thisistemporary.
around the inside of the oven
is normal for the first few times
the oven is used.
LOCappears in The Range Lockout feature . Besure the surface unit controls are turned OFF.
the display is activated. Turnthis feature off to use the range.
Seethe RangeLockout section.
Fan noise The convection fan may turn . This isnormal. To maximize cooking evenness,
on and off automatically, the fan is designed to operate in both directions
with a pause in between.
Convection fan Preheat temperature . Fanwill start automatically oncethe preheat
not working not reached, temperature is reached.
Drawer does not slide Thedrawer is out of alignment. • Fullyextend the drawer and push it all the way in.
smoothly or drugs Seethe Coreand cleaning of the range section.
Drawer is overloaded or load . Reduceweight. Redistributedrawer contents.
is unbalanced.
Lower oven drawer A fuse in your home may be • Replacethe fuse or reset the circuit breaker.
will not work blown or the circuit breaker tripped.
The upper oven is self-cleaning. • Wait for the self-clean cycle to finish and the oven
to cool.
Controls improperly set. . Seethe Lower ovendrawer section.
Excessivecondensation Liquid in drawer. • Removeliquid.
in the drawer
Uncovered foods. . Cover food with lidor aluminum foil.
Temperature setting too high. . Reduce temperature setting.
Food dries out in the Moisture escaping. • Cover food with lidor aluminum foil.
lower oven drawer
Oven drawer not fully closed. . Pushdrawer in until latch engages. /49
To Next Page
Loading...
